Factorio Forums

Please see the attached save game file.



When I put 2 splitters there that the fast inserters are going to grab from, only the top 2 were working. I checked the F5 debug hitboxes and they should be able to load the train. Where it gets more odd is if you put a splitter in the dead center. Then both the middle inserters will load the train. But if you put a splitter on the bottom, then the bottom two fast inserters won't load the train.

I'm replacing this with a little buffer system of course but since I stumbled across this seeming bug I wanted to report it.

Same behavior with the buffer system in place. Bottom two inserters don't run. You can see ore sticking out of the splitter on bottom though.



It isn't an issue of being short of ore on the lower half, if you remove top splitter still nothing.

Thank you for reporting, this will be fixed for next release.