Factorio Forums

after upgrading from 0.11.08 to 0.11.11 items on my belt stop moving in a corner.
i clear the coner with F to pick up the items about 10 times now, they start moving again, wait 2 min till the bottom row is full again.

then 10sec later items on belt are stopped again.

Replaced it with express belts, and it runs normal again.

replacing them back with fast belts, and items on the belt are stopped again in a few min.

this worked in 0.11.8

I had the same problem
I reported it there:
https://forums.factorio.com/forum/vie ... f=7&t=3162

Cordylus wrote:It still exists ingame.
I met this bug with the copper plates on the express belt in 0.11.7

Hello, it is duplicate of: https://forums.factorio.com/forum/vie ... f=7&t=3162

P.S. Until it is solved it is good idea to avoid putting stuff on curve and using this special case of junction.