[0.17.76] Train Rectangle Misalignment
Posted: Mon Nov 11, 2019 8:07 am
When placing an inserter next to a rail segment in a station when a train is in the station, the selector that appears showing the train car affected by the inserter is misaligned with the segment. See figure 1:
This only happens when the inserter is actually adjacent to the rail segment, however:
To highlight the incorrect placement, I marked up this image:
This even occurs when the target train object isn't a locomotive, or the first object in a train, or the inserter is pointing away from the train:
Since I was trying to place a blueprint when I noticed this, I tried without a blueprint. Same problem:
Vertical trains are still slightly off, though. Here's the basic selector for a vertical train:
And a vertical train when I'm placing an inserter adjacent to it:
But this issue ONLY happens when a train is in the station:
To show where I would expect the highlighting selector to appear, I marked up this image:
Looking through the debug options all the collision boxes appeared to be correct, so this looks like it might just be a visual thing.
- Shows misaligned selector.
- Horizontal misaligned.png (1.13 MiB) Viewed 1065 times
- Shows selector without adjacent inserter
- Horizontal basic.png (3.59 MiB) Viewed 1065 times
- Highlights misaligned selector
- Horizontal misaligned (markup).png (1.08 MiB) Viewed 1065 times
- Misaligned on 3rd object in train, a wagon
- Horizontal wagon.png (1.83 MiB) Viewed 1065 times
- Misaligned with no blueprint
- Horizontal no blueprint.png (627.44 KiB) Viewed 1065 times
- Vertical selector without adjacent inserter
- Vertical basic.png (2.67 MiB) Viewed 1065 times
- Vertical selector with adjacent inserter
- Vertical misaligned.png (1.84 MiB) Viewed 1065 times
- Horizontal no train.png (1.69 MiB) Viewed 1065 times
- Vertical no train.png (1.78 MiB) Viewed 1065 times
- Shows where selector is expected to appear
- Vertical basic (markup).png (2.1 MiB) Viewed 1065 times