Factorio Forums

Hi,

I am new to Factorio. I am trying to set up a fairly basic circuit to read a train contents. If the contents of a particular item is less than 500, then fill it.

I have attached a red wire from an inserter to the train stop. I've enabled read train contents and the inserter works. However, when the train goes away from the station, i've noticed that now the station is disabled. Any ideas what i'm doing wrong here?

Andy

By default a circuit network controls station enable/disable. Did you leave that default additionally to reading train contents?

Erm, not too sure. Where would i find that setting?

The station enable/disable setting is in the same place you found the read train contents setting.