[0.17.53] Signal on curved rail bounding box problem
Posted: Mon Jul 01, 2019 4:45 pm
I was about to report the bounding box of curved rails not being symmetric, then I saw the next release and updated.
The problem is the signal on the curved rail in my 0.17.52 save which should have been disabled, remained active.
On 0.17.52 it was possible to place signal on the curve in these situations:
But not in these:
I was designing a square (screenshot from 0.17.53):
(Which unfortunately didn't work when rotated so I found the symmetry bug)
You can see the chain signal is still working (it’s not blinking) but when removed, it can't be placed again.
BTW, I don't remember the behavior before new changes, But I think the bounding box is a little too big.
I would assume it should be possible to place a signal in this long curve:
The problem is the signal on the curved rail in my 0.17.52 save which should have been disabled, remained active.
On 0.17.52 it was possible to place signal on the curve in these situations:
- 1.PNG (279.15 KiB) Viewed 1030 times
- 2.PNG (315.81 KiB) Viewed 1030 times
- 3.PNG (273.19 KiB) Viewed 1030 times
- 4.PNG (294.53 KiB) Viewed 1030 times
I was designing a square (screenshot from 0.17.53):
- 0.PNG (2.39 MiB) Viewed 1030 times
You can see the chain signal is still working (it’s not blinking) but when removed, it can't be placed again.
BTW, I don't remember the behavior before new changes, But I think the bounding box is a little too big.
I would assume it should be possible to place a signal in this long curve:
- 5.PNG (507.91 KiB) Viewed 1030 times