Page 1 of 1
Reduce radius of curve rails just a tiny bit
Posted: Wed May 22, 2019 4:45 pm
by mrvn
TL;DR
The radius of curved rails should be reduce a tiny bit so that fluid wagons align with pumps.
What ?
When a long train stops so that the tail curves around 180° the remaining fluid wagons do not align with pumps and the pumps do not engage.
- curved-train.png (1.98 MiB) Viewed 476 times
The same setup works fine with cargo wagons because their positioning doesn't have to be exact. I tried adding some straight or diagonal pieces and even an S curve into the turn to get the alignment back but didn't find any combination that would work. Looks like the radius of the curved rails should be reduces just a tiny bit so the wagons align.
Why ?
I want to build compact fluid stations like above trading height for width.
Re: Reduce radius of curve rails just a tiny bit
Posted: Wed May 22, 2019 5:31 pm
by eradicator