Page 1 of 1

[0.17.5] Broken UI on selecting assembling machine

Posted: Tue Mar 05, 2019 8:58 pm
by Arin
This happened during the second passage of the company "arrival". Without modifications. The first pass was on version 0.17.4, at that time everything was fine.
Reproduction:
1. Load the save.
2. Move the mouse to the assembly machine.
As you can see, the research bar becomes vertical, information about the assembly machine is also displayed vertically and not completely. Screenshots, save and log file attached.
Reloading the map solves the problem until you hover the mouse over the assembly machine again.

Re: [0.17.5] Broken UI on selecting assembling machine

Posted: Tue Mar 05, 2019 9:01 pm
by invisus
Should be fixed in the just released 0.17.6: Right panel sizing fixes.

Re: [0.17.5] Broken UI on selecting assembling machine

Posted: Tue Mar 05, 2019 9:13 pm
by CDarklock
invisus wrote: Tue Mar 05, 2019 9:01 pm Should be fixed in the just released 0.17.6: Right panel sizing fixes.
Yeah, I think it is. I had the same problem, but it went away in 0.17.6 - thank GOD, it was AWFUL