Factorio Forums

Question is in the title.

I wanted to test some stuff in-game and loaded an old mp-savegame, so I don't have to start from scratch.
Unfortunally using commands was disabled when the game was started. So is there a way to enable them again?

Simply start a multiplayer game (doesn't matter that you are alone) and tick the marker which says something like "Enable console commands" or something. It's right there under the bar to configure latency (put that down to like 20ms, btw).

Now it should be working.

Doh.. stupid me. Tested loaded the save in singleplayer only and forgot that you can change the settings again when you load/continue a mp-game...

Thanks