Page 1 of 1
Expose transport line spacing
Posted: Fri Oct 26, 2018 4:14 pm
by Therax
See
63038. I would envision this as a startup only setting, possibly a "utility-constant". I'm hoping this is something that can be done, especially since in 0.16 transport lines can already be "overfilled" temporarily due to inserter and sideloading behavior.
Re: Expose transport line spacing
Posted: Fri Oct 26, 2018 5:46 pm
by Bilka
From what I can see, allowing this to be defined by mods would require changes that negatively impact the performance of all belts, so I am not going to add this.
Re: Expose transport line spacing
Posted: Fri Oct 26, 2018 6:06 pm
by eradicator
Bilka wrote: Fri Oct 26, 2018 5:46 pm
From what I can see, allowing this to be defined by mods would require changes that negatively impact the performance of all belts, so I am not going to add this.
Even if it was one setting for all belts, not a per-prototype value? (as suggested in the mentiond other thread)