[0.16.51] Rotated 1x2 assembler not placed correct
Posted: Fri Oct 19, 2018 10:53 am
Hi,
I created a 1x2 assembler.
When placing the assembler as is it works as expected.
Rotating this placed container also works OK.
When rotating before placing, the assembler is placed on a 2x3 tile position, also making the pipe_connection unusable -> This is the issue.
Checked also with splitter and pump, they are placed on a correct position.
In the picture below, the red rectangles are the collision-boxes of the entities.
I attached a small mod implementing the assembler-test and a savefile which uses only the testmod and creative mod 0.0.32
I created a 1x2 assembler.
When placing the assembler as is it works as expected.
Rotating this placed container also works OK.
When rotating before placing, the assembler is placed on a 2x3 tile position, also making the pipe_connection unusable -> This is the issue.
Checked also with splitter and pump, they are placed on a correct position.
In the picture below, the red rectangles are the collision-boxes of the entities.
- assembler-test.JPG (53.34 KiB) Viewed 3346 times