Factorio Forums

From a train schedule, opened search dialog to find a station. Pressed '4' and the game crashed. I've used search and numbers before, without problems.

The long steps is, from YARM mod, I used an 'eye' button to open a copper mine that was running low. I'd just built a new mine and was going to send the train there after a short wait period.
I clicked the station from map view.
Then I clicked the train.
Then I went to add a stop after current mine.
Then I used the search icon.
Then I typed 46, but the game crashed on 4.
Since my base file is so big, I put on google drive: here's the link to the save file, ~65MB: https://drive.google.com/file/d/17GFnLo ... sp=sharing

Edit: Noticed there was a dump file and attached it as well.

Just had the same crash again (coincedently?) pressing 4, except I wasn't using YARM to pull up the train. Here's a screenshot:



Here's the autosave on Google Drive: https://drive.google.com/file/d/1-3dp7y ... sp=sharing

Attached are the log file, mods and dump.

With that last save game, I've crashed twice in a row within seconds of loading the game.

1) Load the game,
2) Minimize YARM (button at the top left of all that mining information, just under rockets icon) (not sure if this is required, but it's what I've done last two loads)
3) Switch to map mode
4) Choose the station "Copper Ore 35N"
5) Choose the train not set to manual, the manual one is my personal maintenance train
6) Be sure the Copper Ore 35N is selected,
7) then choose add station,
8) Open the search dialog at the top and type 48. It's crashed on the 8 and the 4 since the above post.

Now that I write this, I can't duplicate it again, but maybe you can.

Thanks for the report, it is now fixed for 0.16.44