Page 1 of 1
.16 belt impèrovement verification
Posted: Sat Dec 16, 2017 5:22 pm
by dinodod
How do I test the belt performance in .16? On eh debug screen each belt is still 1 tile and performing collision checks. How are the belts optimized then? It was my understanding the belts were going to be grouped. Did I miss a post?
Re: .16 belt impèrovement verification
Posted: Sat Dec 16, 2017 5:56 pm
by Frightning
dinodod wrote:How do I test the belt performance in .16? On eh debug screen each belt is still 1 tile and performing collision checks. How are the belts optimized then? It was my understanding the belts were going to be grouped. Did I miss a post?
What sort of performance are you trying to test? UPS? throughput? need more information here.
Re: .16 belt impèrovement verification
Posted: Sat Dec 16, 2017 9:48 pm
by Koub
Make a huge base on 0.15 with lots of belts, up to the point you have significant UPS drop.
migrate to 0.16.
You'll be able to measure the improvement.