[Twinsen][0.16.3] Placing circuit wire blueprint over train signals does not work
Posted: Sat Dec 16, 2017 6:11 am
I believe there was some discussion about how this should work in the lead up to 0.16 and I'm not 100% sure on the outcome, however I have found an inconsistency with wiring between entities on blueprint.
If you have two entities that are not connected with red/green wire (such as two inserters) then you run a blueprint over it with a wire connection present it will result in the two entities being wired together.
This seems to work for all entities except for rail and/or chain signals.
This picture below should help demonstrate what I'm saying.
If you have two entities that are not connected with red/green wire (such as two inserters) then you run a blueprint over it with a wire connection present it will result in the two entities being wired together.
This seems to work for all entities except for rail and/or chain signals.
This picture below should help demonstrate what I'm saying.
PIC
