Factorio Forums

Posted: **Thu Dec 14, 2017 11:29 pm**

I placed a locomotive in world, clicked on it to open the control panel. The GUI for automated travel setup is clipped, which makes it unusable.
The two visible buttons work, but there's no way to switch the train into automatic mode or to manually set the current destination.
My screen resolution is 1366x768, running on Arch Linux.
See attached image:

: Screenshot of the clipped GUI; locomotive-clipped-gui.png (681.2 KiB) Viewed 2471 times

Posted: **Thu Dec 14, 2017 11:55 pm**

Does the issue persist if you scale down to, say, 80% GUI scale?

Posted: **Fri Dec 15, 2017 1:05 pm**

Yes, unfortunately it does (80% scale, the minimum that can be set using the slider):

: Screenshot at 80% UI scale; Zrzut ekranu z 2017-12-15 13-03-22.png (986.16 KiB) Viewed 2427 times

Posted: **Sat Dec 23, 2017 8:01 pm**

I think I have found the cause of this. It's not the resolution, I got the same clipped gui on my 1080p monitor. However, when not using the 500 inventory slots mod the issue disappears - somehow the additional inv. slots mess up the gui.

Posted: **Sat Dec 23, 2017 8:10 pm**

See: viewtopic.php?f=182&t=55378

Factorio Forums

[16.2] Clipped locomotive GUI when using 500 inventory slots

[16.2] Clipped locomotive GUI when using 500 inventory slots

Re: [16.2] Clipped locomotive GUI on 1366x768 resolution

Re: [16.2] Clipped locomotive GUI on 1366x768 resolution

Re: [16.2] Clipped locomotive GUI on 1366x768 resolution

Re: [16.2] Clipped locomotive GUI when using 500 inventory slots