Page 1 of 1
4:4:1 Belt Splitter
Posted: Thu Jun 01, 2017 6:33 am
by Boldar
Hi,
i am in need of something interesting: a balanced way to branch off a sinle lane from 4 belts, so that it draws even from them.
- splitters.png (1.25 MiB) Viewed 9401 times
The Design on the left is my current working point, although i am not entirely sure if it is really perfect. The right one is more compact, but only extracts a red belt. I would be interested in any improvements or other ideas. Do note that it is not a full 4:5 Balancer, as the 4 original lines remain unchanged.
Re: 4:4:1 Belt Splitter
Posted: Thu Jun 01, 2017 8:34 am
by SeigneurAo
Wouldn't it be easier to branch your new lane straight away with a splitter, then use a standard 4-4 balancer after that ?
Re: 4:4:1 Belt Splitter
Posted: Thu Jun 01, 2017 9:27 am
by Boldar
That way, the new lane would only get half throughput if nothing backs up, and might not get any if only one input lane is filled.
Re: 4:4:1 Belt Splitter
Posted: Thu Jun 01, 2017 9:37 am
by SeigneurAo
Boldar wrote:That way, the new lane would only get half throughput if nothing backs up, and might not get any if only one input lane is filled.
True dat...
I wrongly assumed the 4 lanes were already balanced, for some reason (as in your main bus or something).
Re: 4:4:1 Belt Splitter
Posted: Thu Jun 01, 2017 10:15 am
by Lav
My suggestion is to do a prioritized split from each belt separately, and then place a 4-to-1 balancer to the side of the main bus.
Re: 4:4:1 Belt Splitter
Posted: Thu Jun 01, 2017 2:40 pm
by Shokubai
This is my go to.
You add a balancer on the top of the output to reduce it to one lane.
- 1.png (231.94 KiB) Viewed 9349 times
Re: 4:4:1 Belt Splitter
Posted: Fri Jun 02, 2017 11:00 am
by Engimage
One I am using
- 4-belt-splitter.jpg (105.42 KiB) Viewed 9297 times
Makes a perfect split to 2 sides. One side can be just not used or undergrounded to 2nd for 2 belt split.
Keeps your bus looking fully saturated unless you consume more than you provide then bus dries out proportionally.