Page 1 of 1

[0.15.10] Inserter not inserting

Posted: Thu May 11, 2017 9:18 am
by nuhll
Hi,
some of the isnerters just are stuck, i didnt had any coal so i added another lane, also i noticed it different times before they get sometimes stuck.
1221.jpg
1221.jpg (3.16 MiB) Viewed 3234 times

Re: [0.15.10] Inserter not inserting

Posted: Thu May 11, 2017 9:36 am
by Loewchen
They can not grab moving coal from fast belts.
Duplicate of: viewtopic.php?f=23&t=35853

Re: [0.15.10] Inserter not inserting

Posted: Thu May 11, 2017 9:55 am
by nuhll
O, rly, i know. :D

The belt is not moving. (how else should the others get coal?!)

Removing and place again works btw also.

Move it back, thanks.

Re: [0.15.10] Inserter not inserting

Posted: Thu May 11, 2017 10:53 am
by alexzzzz
nuhll wrote:The belt is not moving. (how else should the others get coal?!)
It's not moving now, when the unlucky inserters are already out of fuel. It usually happens to the inserters that are closer to the fuel input and never happens to the ones that are at the end of the lane.

Re: [0.15.10] Inserter not inserting

Posted: Thu May 11, 2017 12:17 pm
by nuhll
???

Should they be able to pick up fuel by itself? Yes or no?

Re: [0.15.10] Inserter not inserting

Posted: Thu May 11, 2017 12:36 pm
by daniel34
nuhll wrote:???

Should they be able to pick up fuel by itself? Yes or no?
Yes, but if the fuel goes past them too fast (red or blue belt) they can't grab it. They'll try a few times and inevitably run out of fuel.

You also wrote
nuhll wrote:i didnt had any coal so i added another lane
so at some point the belt had to be moving.

Re: [0.15.10] Inserter not inserting

Posted: Thu May 11, 2017 12:40 pm
by nuhll
Yes, but atm it was not moving 1/4 of all inserters just chilling.

Doin nothing.

I Understand that they cant take it when it moves too fast. But why they cant take when the BELT is NOT moving?

Re: [0.15.10] Inserter not inserting

Posted: Thu May 11, 2017 5:10 pm
by alexzzzz
nuhll wrote:But why they cant take when the BELT is NOT moving?
Because they out of fuel and have no energy to move.

When you place a new burner inserter it has a little bit of fuel to be able to move to refuel itself. Some of your inserters ran out of fuel completely, so they can't even refuel themselves.

Re: [0.15.10] Inserter not inserting

Posted: Fri May 12, 2017 8:47 am
by nuhll
So burner inserters cant refuel itself when complete out of fuel. Thats not cool.