Factorio Forums

Hi guys,

everytime i tryed to use the network connection of train stops they go red and no condition i have tryed has worked and gave me an green signal. i tested the same conditions with standard train signals and there it worked.

could you guys please look in the setup of train stops and give an explanation how the train stop network connection should work, or rather if it doesn't work yet.

Post a save, describe exactly which signal should do what and why.

I have connected my steel chests at the Train stop "Entladung" with an red cable to all other train stops.
There is only 2.3k coal in the network and at the train station "Kohle1" i have writen it should enable when the network says there are lower than 6.0k coal.
But all the time the train stop stays red

You have a logistic condition on the station as well, deactivating that "fixes" it, but I don't see a reason why it should behave like this...yet.

thanks, i deactivated in all stations the logistic network and now it works

It seems that logistic and circuit conditions both have to be true for the station to activate. Once you activate any logistic condition outside a logistic network the station will deactivate no matter the circuit condition.

Loewchen wrote:It seems that logistic and circuit conditions both have to be true for the station to activate. Once you activate any logistic condition outside a logistic network the station will deactivate no matter the circuit condition.

Correct. That's why the "connect" option exists in the logistics tab. If you have it connected then it and the circuit condition both have to be true for it to be active.

That's by design. If you don't want the logistic condition to be checked the un-check the "connect" option in the GUI