Page 1 of 1
Blueprinting inserters with circuit conditions
Posted: Mon Mar 20, 2017 2:42 pm
by wahming
I noticed that when using blueprints, my inserters do not have their circuit conditions reproduced. What's the best way to replicate large setups in this case?
Re: Blueprinting inserters with circuit conditions
Posted: Mon Mar 20, 2017 3:12 pm
by Yoyobuae
wahming wrote:I noticed that when using blueprints, my inserters do not have their circuit conditions reproduced. What's the best way to replicate large setups in this case?
They do, but only if the inserts is actually placed by a bot.
If the inserter is already placed and you place matching blueprint on top of it then it wont work. Same if you try manually placing the inserters on top of the blueprint ghosts.
Re: Blueprinting inserters with circuit conditions
Posted: Mon Mar 20, 2017 3:15 pm
by wahming
Oh oops! I just realised that. My bad, thanks
Re: Blueprinting inserters with circuit conditions
Posted: Tue Mar 21, 2017 9:02 am
by The Eriksonn
I also think it is annoying that pasting iron chests with wires ontop of a wood chest forgets the wires...
