Trains Stuck "for no reason"
Posted: Mon Jan 30, 2017 7:45 pm
Hey together,
I have a train-network, that is utilizing "single rails" between hotspots. This works fine most of the time, but sometimes,
trains are getting stuck for no obvious reason.
I know about the magic of traffic-lighting (direction, chaining, etc) however, in this case i just can't figure out, why the trains are "stuck":
- The Topmost intersection works "fine", trains are intendet to leave the whole "thing" unentered, if a train is inside.
- The lower "port" is just a port loading stuff for 100 seconds, then leaving. However, this never happens. Even if the following signs are "green", the trains are
stuck at this particular station....
ps.: this "stuck" only appears from time to time - so the "general layout of "moving" seems right...
Any idea?
I have a train-network, that is utilizing "single rails" between hotspots. This works fine most of the time, but sometimes,
trains are getting stuck for no obvious reason.
I know about the magic of traffic-lighting (direction, chaining, etc) however, in this case i just can't figure out, why the trains are "stuck":
- The Topmost intersection works "fine", trains are intendet to leave the whole "thing" unentered, if a train is inside.
- The lower "port" is just a port loading stuff for 100 seconds, then leaving. However, this never happens. Even if the following signs are "green", the trains are
stuck at this particular station....
ps.: this "stuck" only appears from time to time - so the "general layout of "moving" seems right...
Any idea?
. 