Factorio Forums

these two stops are off the same tracks that are perpendicular to the stations.
i made the copper one on the right first which is functional. using the grid i made a mirror image of the stop to make it easier.
attempted to mirror the signals but it's stopping a block short of where i need it.

Did you try placing the curve down again or place the signals before the curve.
I had some tight spots where signals worked by placing switches afterwards.

i tried picking them up and placing them again, and no luck.
placing the signals then the curves the train gives a 'no path' error.
i endded up moving the stop up 1 (2 blocks) which took some clever manuvering considering the chest were full.
from now on i'm going to make the stops larger so i don't run into this again.