Page 1 of 1
[0.13.1][Twin] Inserters can't just report to the c. network
Posted: Wed Jun 29, 2016 10:09 pm
by jcranmer
The button to Enable/Disable the mode of operation and just have it report the statistics appears to be broken for inserters--if I try to change it, it doesn't work. I tested it with the fast inserter and the long-handed inserter.
Re: [0.13.1] Inserters can't just report to the circuit network
Posted: Wed Jun 29, 2016 10:19 pm
by Loewchen
I can confirm that the dot in the radio button can not be removed (that is how those buttons work?!) and once an inserter has a signal-cable connected it only performs if its condition is true.
The radio button should be a checkbox imo.
Re: [0.13.1] Inserters can't just report to the circuit network
Posted: Wed Jun 29, 2016 10:29 pm
by Shaymes
you can setup
so its TRUE if is any item in the network
or add a constand combinator to set something to a value maybe A = 1 for always on
Re: [0.13.1] Inserters can't just report to the circuit network
Posted: Wed Jun 29, 2016 10:52 pm
by Loewchen
I get it now, the button only has an alternative if its a filter inserter, to only have the signal connection to detect items, you need a workaround to keep it operating then.
Re: [0.13.1][Twin] Inserters can't just report to the c. network
Posted: Thu Jun 30, 2016 10:23 am
by Twinsen
I added the "None" option for more flexibility.
You will see this in Version: 0.13.2
- Capture.PNG (24.94 KiB) Viewed 1791 times