Factorio Forums

So i've gotten into circuits just now and within 15minutes of playing around I ran into a problem - there doesn't seem to be a good way of comparing values from red and green circuits. So lets imagine this situation:

Red circuit content:
10 gears
10 iron plates
10 copper plates

Green circuit content:
5 gears

Now I want to create a statement along the lines of:

For <item> in <red circuit>
if <item> is less than <same item in green circuit>
send out signal A with the value of (<item in red circuit> - <item in green circuit>)

so that in the case of gears I get an output in the green circuit of Ax5, since the difference between gears in two circuits is 5.

This is possible to do if the items are pre-determined and there's a low amount of different items, since we can output a specific item's count as some other item, BUT - that requires dealing with a huge set of temporary replacement values for each item and in the end it's pretty much impossible to do if I want the logic to apply to a big set of different items.

As such my question is - is there any way to compare values of the same item from different circuits without converting the item's count to a different signal with the same count (as this would be the absolute opposite of automation - requiring to manually configure hundreds of different items and their replacement values)


Edit:

It is also good if I could at least do this:

For <item> in <red circuit>
if <item> is less than <same item in green circuit>
send out signal A to red circuit
else
send out signal A to green circuit

You can multiply each signal of one color by -1 before connecting them, then you can decide what to output depending on whether the result is negative, 0 or positive.

Choumiko wrote:You can multiply each signal of one color by -1 before connecting them, then you can decide what to output depending on whether the result is negative, 0 or positive.

Genius. How did I not think of this - thanks a lot!