Factorio Forums

With the signals set the train moves according to the book / but with the keyboard code W or other it won't move a bit and i'm getting a "No Path" error - what I'm doing wrong?

It looks like you have no train stop on this small loop. Did you set the schedule to run to a train stop on a different network?

Edit: If you want to manually drive the train you have to stop it. You can't manually drive a train that is set to run on an automatic schedule. Use the button with the two vertical lines (I think it's supposed to be a "pause" symbol) to stop the automatic schedule.

sillyfly wrote:It looks like you have no train stop on this small loop. Did you set the schedule to run to a train stop on a different network?

No - I just have set up this single loop for trial and try to get the train moving - the auto schedule is disabled.

The "No path" means the train is trying to run an automatic schedule. See my edit.

You have to stop the automatic run.

sillyfly wrote: You have to stop the automatic run.

there isn't any as far as I can see - thank you for your dedication

Which keyboard code is working for you?

Driving the train should be similar to driving the car - you have to be in the locomotive (press Enter while near enough to get inside, press Enter again to exit). 'w' should accelerate, 's' should decelerate/move backwards. 'a' and 'd' should choose between left and right turns in a fork/junction.

Thats exactly what I do - it seems to be a bug in the Mac version

You press w and the locomotive doesn't move? It takes time to accelerate, so you have to hold w for a few seconds...

sillyfly wrote:You press w and the locomotive doesn't move? It takes time to accelerate, so you have to hold w for a few seconds...

I just found that the train moves perfectly on the mac when pressing the up/ down buttons - probably this hat to do with my german keyboard Im using