Page 1 of 1
[2.1.13] Placing a parameterised blueprint opens parameter selection menu at cursor position
Posted: Wed Aug 05, 2026 2:18 pm
by rosalktha
When placing a paramterised blueprint, the menu opens where the cursor is, instead of at the usual neutral spot. Unsure if this is actually a bug, but I noticed it because it gives me a weird motion sickness.
Always seems to happen.
Re: [2.1.13] Placing a parameterised blueprint opens parameter selection menu at cursor position
Posted: Wed Aug 05, 2026 2:20 pm
by Rseding91
Thanks for the report. This is intended and requires specific logic on the engine side for it to behave this way. It's intended to reduce the amount of time required to configure the single parameter selection when placing the blueprint.
Re: [2.1.13] Placing a parameterised blueprint opens parameter selection menu at cursor position
Posted: Thu Aug 06, 2026 1:23 pm
by rosalktha
Thanks for the clarification - makes sense. I'll get used to it, hopefully.