[Not a bug] [2.1.9] Cannot manually set "Landing pad unloading bay" as a filter in inserters/splitters/storage chest
Posted: Sat Jul 04, 2026 10:22 am
edit: Turns out It was because I didn't have the research for this item. With the research done, it shows up.
While adding unloading bays to my mall, i noticed that I was unable to set them as filters.
Repro steps:
1) Place inserter
2) Check "Use filters" box
3) Attempt to set "Landing pad unloading bay"
Same issue with splitters and storage chest.
Interestingly, if I use "Set Filters" with a constant combinator to set the filter, then I am still able to specify the filter.
Also, if I drag & drop an actual item in the filter, then the filter is also set just fine.
While adding unloading bays to my mall, i noticed that I was unable to set them as filters.
Repro steps:
1) Place inserter
2) Check "Use filters" box
3) Attempt to set "Landing pad unloading bay"
Same issue with splitters and storage chest.
Interestingly, if I use "Set Filters" with a constant combinator to set the filter, then I am still able to specify the filter.
Also, if I drag & drop an actual item in the filter, then the filter is also set just fine.
- Screenshot From 2026-07-04 03-14-07.png (127.58 KiB) Viewed 127 times
- Screenshot From 2026-07-04 03-17-20.png (138.92 KiB) Viewed 127 times
- 07-04-2026, 03-27-40.png (131.78 KiB) Viewed 118 times
- 07-04-2026, 03-23-50.png (77.61 KiB) Viewed 125 times