Page 1 of 1
[2.1.9] Edit: was my own fault (inserter stuck at waiting for items while belt is full)
Posted: Wed Jul 01, 2026 6:35 pm
by orangemammut
I just noticed that one of my inserters was stuck on 'waiting for source items' on a full belt. Probably because right opposite was another inserter trying to drop an item on that same belt and that one was stuck on target full. I think maybe they were waiting for each other. I could solve the problem by placing another inserter right next to it.
EDIT: I just found the issue: all items on the belt had more than normal quality!
Re: [2.1.9] inserter stuck at waiting for items while belt is full
Posted: Wed Jul 01, 2026 7:11 pm
by Rseding91
Thanks for the report. Do you know of any way to get the inserter into this stuck state from a working state?
Re: [2.1.9] Edit: was my own fault (inserter stuck at waiting for items while belt is full)
Posted: Wed Jul 01, 2026 7:12 pm
by orangemammut
sorry, see my edit in the post, I just noticed the quality of the red circuits. So it isn't a bug
Re: [2.1.9] Edit: was my own fault (inserter stuck at waiting for items while belt is full)
Posted: Wed Jul 01, 2026 7:16 pm
by orangemammut
only whats weird is that the dots are not visible on the items on the belt. Isnt it normally the case that you'd see those dots?
See attached screenshot for how it's now stuck again.