[Klonan] [2.1.8] Science production information graph takes 1 tick to populate after popping up, and expands
Posted: Sat Jun 27, 2026 1:19 pm
What did you do?
Hover over the top-right science graph
What happened?
There was some visual popping every time I did this, which felt very off.
What did you expect to happen instead?
No visual popping - either the widget should be full size on pre-populated hover, or ideally, the widget is populated when it's first rendered.
Does it happen always, once, or sometimes?
Always happens
In 2.1, a new addition to the on-hover science graph was added which shows the amount of science packs needed for the current research.
However, the "pre-populated" widget, which exists for 1 tick, is slightly smaller as it lacks space for the "amount of science packs" needed area. This causes some visual noise every time you hover over the science graph.
Hover over the top-right science graph
What happened?
There was some visual popping every time I did this, which felt very off.
What did you expect to happen instead?
No visual popping - either the widget should be full size on pre-populated hover, or ideally, the widget is populated when it's first rendered.
Does it happen always, once, or sometimes?
Always happens
In 2.1, a new addition to the on-hover science graph was added which shows the amount of science packs needed for the current research.
However, the "pre-populated" widget, which exists for 1 tick, is slightly smaller as it lacks space for the "amount of science packs" needed area. This causes some visual noise every time you hover over the science graph.
- 06-27-2026, 15-16-37.png (909.04 KiB) Viewed 200 times
- 06-27-2026, 15-16-25.png (1.03 MiB) Viewed 200 times
