Page 1 of 1
[2.1.7] Fast replacing inserters resets lane prefrence
Posted: Tue Jun 23, 2026 2:43 pm
by pepciorek
- obraz.png (157.56 KiB) Viewed 259 times
Original setup
But when it's fast replaced manually, this happens
- obraz.png (75.22 KiB) Viewed 259 times
The upgrade planner works as intended, keeping the original lane preference
Re: [2.1.7] Fast replacing inserters resets lane prefrence
Posted: Tue Jun 23, 2026 2:48 pm
by boskid
inserter's preference is not part of settings but part of its direction/mirroring. Are you manually building normal inserters or flipped inserters? Inserter gets whatever your cursor is when building making this not a bug. It would be easier to explain with a recycler but it behaves the same with drills and inserters where cursor's flip affects flip of the entity built.
Re: [2.1.7] Fast replacing inserters resets lane prefrence
Posted: Tue Jun 23, 2026 2:52 pm
by pepciorek
- obraz.png (123.26 KiB) Viewed 234 times
I'm manually placing the inserter over the existing one, I can change its lane preference, but originally when placing a new inserter, it suggests a default configuration. I think it would be good for them to copy it over to the new entity
Re: [2.1.7] Fast replacing inserters resets lane prefrence
Posted: Tue Jun 23, 2026 2:59 pm
by boskid
I am going to move this to Not a bug as this is currently working as intended: inserter inherits flip state from cursor, not from entity being overbuilt.