Page 1 of 1
[Lou][2.0.77] Train disconnected after force printing
Posted: Tue Jun 16, 2026 6:16 pm
by AntiElitz
https://youtu.be/s98rl8DLAFA
Saves and Blueprints attached
Re: [Lou][2.0.77] Train disconnected after force printing
Posted: Wed Jun 17, 2026 4:23 pm
by Lou
Hi and thanks for the report. This specific case actually did not disconnect in versions (at least) 2.1.4 and later, have you run into analogous issues? (Issues when fast reviving are known)
Re: [Lou][2.0.77] Train disconnected after force printing
Posted: Wed Jun 17, 2026 7:50 pm
by AntiElitz
This is the only case I am aware of. If it's already fixed for 2.1, that is great!