Page 1 of 1
[Bob's Power 2.0.2] Is Boiler water consumption supposed to be 60 per second?
Posted: Tue Jan 13, 2026 8:58 pm
by cbtmessageman
Greetings.
A quick review: Prior to Factorio 2.0 Boilers would consume up to 60 water/second. This was changed in 2.0 to 6 water/second. In Bob's Power the Boilers are drawing 60 water/second. Is this intentional?
Thanks.
Re: [Bob's Power 2.0.2] Is Boiler water consumption supposed to be 60 per second?
Posted: Tue Jan 13, 2026 9:27 pm
by eugenekay
Are you using any other Mods which modify the energy value of Steam or temperature of the input Water? The numbers all seem correct when running just
Base and the
Bob's Power mod.
- 01-13-2026, 16-26-09.png (1.15 MiB) Viewed 236 times
Re: [Bob's Power 2.0.2] Is Boiler water consumption supposed to be 60 per second?
Posted: Wed Jan 14, 2026 4:13 pm
by cbtmessageman
eugenekay wrote: Tue Jan 13, 2026 9:27 pm
Are you using any other Mods which modify the energy value of Steam or temperature of the input Water? The numbers all seem correct when running just
Base and the
Bob's Power mod.
Loads of mods, taking out the new Bobs & Angels set for a run. Poking around when I dropped Angel's Petrochemical Processing (taking Bioprocessing and Smelting with it) water consumption went back to 6/second. Turning it back on took things back to 60/sec.
I'll take this to the Angel's board.
Re: [Bob's Power 2.0.2] Is Boiler water consumption supposed to be 60 per second?
Posted: Wed Jan 14, 2026 6:06 pm
by eugenekay
This appears intentional:
1071. It maintains "balance" of the various water purity level fluid exchanges.