Page 1 of 1
[Twinsen][2.0.72][switch2] Alt-mode immediately turns off in quick panel
Posted: Tue Dec 23, 2025 12:46 pm
by holmonov2122
If you enable alt-mode in the quick panel (L-button) on Switch 2 (instead of up on the d-pad) and immediately release the L-button, the alt-mode is turned off instantly. If you move the cursor after enabling alt-mode inside the quick panel, however, it stays.
Up on the d-pad works well though...but I don't think this is intended!
Re: [2.0.72][switch2] Alt-mode immediately turns off in quick panel
Posted: Tue Dec 23, 2025 1:58 pm
by holmonov2122
I think I see what's happening...you're supposed to hover over your selection and release the L-button, and then the selection activates. This weird behavior is just because I'm assuming you should click on things with mouse-mode on, and then upon releasing it toggles the alt-mode. Up to you if you think this is even a bug, I'm not so sure anymore...
Re: [Twinsen][2.0.72][switch2] Alt-mode immediately turns off in quick panel
Posted: Wed May 06, 2026 8:02 am
by Twinsen
This is fixed for 2.1:
Don't activate a Quick Panel slot when hiding the Quick Panel, if the slot was already previously pressed manually, either using A or using a mouse.
This should prevent your issue and also allow power users to press a button multiple times before closing the Quick Panel. This is helpful when you want to Undo multiple times so you would press A multiple times before releasing Left Bumper to close the Quick Panel.