[2.0.72] Train stop reports train ID at empty station
Posted: Thu Nov 27, 2025 9:43 pm
1. What did I do?
I connected a train stop to an inserter, with the inserter set to only turn on once a train was at the stop.
2. What happened?
The stop reported a train ID even though no train was present. (The train had been there previously.)
3. What did I expect?
I expected that the train ID would be blank after the train departed.
4. Does it happen once, or always?
I disconnected and re-connected the inserter several times, the empty stop continued to report the train ID as if the train was present.
Once the train returned to the station, it reported the train ID as expected.
Once the train left, then it stopped happening.
I connected a train stop to an inserter, with the inserter set to only turn on once a train was at the stop.
2. What happened?
The stop reported a train ID even though no train was present. (The train had been there previously.)
3. What did I expect?
I expected that the train ID would be blank after the train departed.
4. Does it happen once, or always?
I disconnected and re-connected the inserter several times, the empty stop continued to report the train ID as if the train was present.
Once the train returned to the station, it reported the train ID as expected.
Once the train left, then it stopped happening.
- Don't remove bioflux until train present.png (193.47 KiB) Viewed 99 times
- The train is there and not there.png (92.89 KiB) Viewed 99 times