Page 1 of 1
traffic lights
Posted: Mon Oct 13, 2025 11:15 am
by rvvfd1122
how to set up traffic lights so that two trains do not crash into each other on this section?
Re: traffic lights
Posted: Mon Oct 13, 2025 11:29 am
by jdrexler75
This looks a bit contrived since you could just move one turn down a bit so they don't even touch.
How do you want the trains to move? One-way traffic or two way traffic, from where to where?
Re: traffic lights
Posted: Mon Oct 13, 2025 1:10 pm
by mmmPI
It also depend on the lengh of the trains.
Assuming trains are too long to fit on the horizontal curvy section, you can treat this whole picture as a single junction with 2 entrances and 2 exits and be ok with only 4 signals.
2 chain signals, one on each entrance, on the right side of the track, and 2 regular signal, one on each exit, again on the right side of the track.
This is assuming rails are one way.