Decider Combinator - Additional output signal to "Anything"
Posted: Sat Sep 06, 2025 11:18 am
I have a chest connected to a Decider Combinator. Under conditions I set up OR'ed specific items > 0, serving as a filter. Under outputs, I set "Anything", and "Input Count", to output a single specific item at a time. All good. I then add a control signal "S", and set it to "Input Count" also, yet there is no "S" output signal.
Am I wrong to expect "S" with an output the same as the specific item "Anything" has selected? Is there some reason for it not doing so? My current workaround is to add an Arithmetic Combinator after, and multiply Each with 1, and set "S" as output, to get my control signal. I'd rather not have to add the extra combinator, and I'm a bit surprised that it didn't work as I expected.
EDIT:
Am I wrong to expect "S" with an output the same as the specific item "Anything" has selected? Is there some reason for it not doing so? My current workaround is to add an Arithmetic Combinator after, and multiply Each with 1, and set "S" as output, to get my control signal. I'd rather not have to add the extra combinator, and I'm a bit surprised that it didn't work as I expected.
EDIT:
- 20250906132748_1.jpg (367.52 KiB) Viewed 305 times