[Kovarex] [2.0.47] Display panel parameters won't change in description when connected to a curcuit
Posted: Fri May 23, 2025 2:09 pm
I noticed when i set parameters to the description of the display panel it changes with it, but not when connected to red or green wires.
When connected to a curcuit it only changes the signal condition, but not the description.
I don't know if it's a bug or intended, but otherwise it works when not connected or in the constant combinator description.
When connected to a curcuit it only changes the signal condition, but not the description.
I don't know if it's a bug or intended, but otherwise it works when not connected or in the constant combinator description.
- grafik.png (963.53 KiB) Viewed 392 times