[2.0.47] Outdated or incorrect max priority in priority info in train stop GUI
Posted: Fri May 09, 2025 9:30 pm
In the train stop GUI, when the information icon is hovered over for the priority field, it says 255 is the maximum value. However, the slider only goes to 90.
It would be clearer if the slider went from 0-255 instead of 0-90.
Also, I was able to manually type in a priority of 100,000 with no error. After closing and re-opening the train stop GUI, the value was reset to 255.
This behavior would be clearer if an error popped up when trying to enter a number out of bounds, or the priority field otherwise forbade the user from entering in numbers larger than 255. In my opinion, this would be better than silently ignoring the users request to make it higher.
Granted these are small issues, if issues at all. But I think it would make the GUI more polished if something was done for this and other sliders.
It would be clearer if the slider went from 0-255 instead of 0-90.
Also, I was able to manually type in a priority of 100,000 with no error. After closing and re-opening the train stop GUI, the value was reset to 255.
This behavior would be clearer if an error popped up when trying to enter a number out of bounds, or the priority field otherwise forbade the user from entering in numbers larger than 255. In my opinion, this would be better than silently ignoring the users request to make it higher.
- Screenshot 2025-05-09 150836.png (47.78 KiB) Viewed 134 times
Granted these are small issues, if issues at all. But I think it would make the GUI more polished if something was done for this and other sliders.