[2.0.45]Each Signal Acting as AND instead of OR. Alternatively, Inconsistent behavior
Posted: Tue Apr 15, 2025 5:17 am
1. What did you do?
- Setup decider combinator as pictured below (A).
2. What happened?
- Combinator outputs a single ("signal-0": 1) as pictured (A).
3. What did you expect to happen instead?
- I expected an additional output of ("signal-1": 2) to also appear on the output.
4. Does it happen always?
- Yes.
Picture A:
1. What did you do?
- Setup decider combinator as pictured below (B).
2. What happened?
- Combinator outputs ("signal-0": 1) and ("signal-1": 2) as pictured (B).
3. What did you expect to happen instead?
- I expected a single output of ("signal-1": 2) to appear on the output. ("signal-0" : 1) should not be there.
4. Does it happen always?
- Yes.
Picture B:
Any help would be greatly appreciated,
Thanks!
-igorigorigor
- Setup decider combinator as pictured below (A).
2. What happened?
- Combinator outputs a single ("signal-0": 1) as pictured (A).
3. What did you expect to happen instead?
- I expected an additional output of ("signal-1": 2) to also appear on the output.
4. Does it happen always?
- Yes.
Picture A:
- 04-15-2025, 01-02-48.png (92.67 KiB) Viewed 174 times
- Setup decider combinator as pictured below (B).
2. What happened?
- Combinator outputs ("signal-0": 1) and ("signal-1": 2) as pictured (B).
3. What did you expect to happen instead?
- I expected a single output of ("signal-1": 2) to appear on the output. ("signal-0" : 1) should not be there.
4. Does it happen always?
- Yes.
Picture B:
- 04-15-2025, 01-15-15.png (107.94 KiB) Viewed 174 times
Thanks!
-igorigorigor