[2.0.39] Cut/paste a mid-craft assembler on space platform deletes it
Posted: Wed Mar 12, 2025 2:12 pm
When cutting and pasting a mid-craft assembling machine on a space platform, instead of being re-built at the destination, a ghost at the destination remains and the assembler is nowhere to be seen in the platform's inventory. I also checked and didn't see it getting dropped to the planet.
As best I could tell, title were necessary conditions. Save attached; upon loading it, go to the platform named <space science>. Within a few seconds of loading in the **top-right** assembler should be fed and start crafting. A good second or so after this starts, use the cut tool to attempt to move the assembler 1-2 tiles to the right. It gets deleted, leaving a ghost instead of rebuilding. If you can't reproduce, try again with slightly different timing; it usually reproduced for me but not every time, so I suspect there's something more to it than just the crafting. Either way it reproduces with *some* timing within ~15 seconds of the save load.
I could not reproduce with the smelters on the same platform.
As best I could tell, title were necessary conditions. Save attached; upon loading it, go to the platform named <space science>. Within a few seconds of loading in the **top-right** assembler should be fed and start crafting. A good second or so after this starts, use the cut tool to attempt to move the assembler 1-2 tiles to the right. It gets deleted, leaving a ghost instead of rebuilding. If you can't reproduce, try again with slightly different timing; it usually reproduced for me but not every time, so I suspect there's something more to it than just the crafting. Either way it reproduces with *some* timing within ~15 seconds of the save load.
I could not reproduce with the smelters on the same platform.