[2.0.32] Splitters exhibit different throughput if belt is backed up then allowed to flow again
Posted: Sun Mar 09, 2025 7:02 pm
When mining onto splitters for more throughput, splitters show different behavior based on surrounding conditions.
If the belt is moving and stays moving, the miner outputs to a compressed belt.
If, however, the belt stops for any reason then is allowed to move again, output to belt drops from full speed 240 items/s to single lane speed 120 items/s.
Picking up and re-placing the splitter resolves the issue until the belt backs up again, at which point the issue returns.
Top belt: one that was backed up then allowed to flow again (50% compression)
Bottom belt: allowed to flow without interruption (compressed)
If the belt is moving and stays moving, the miner outputs to a compressed belt.
If, however, the belt stops for any reason then is allowed to move again, output to belt drops from full speed 240 items/s to single lane speed 120 items/s.
Picking up and re-placing the splitter resolves the issue until the belt backs up again, at which point the issue returns.
Top belt: one that was backed up then allowed to flow again (50% compression)
Bottom belt: allowed to flow without interruption (compressed)
- 03-09-2025, 11-57-37.png (1.9 MiB) Viewed 200 times