Page 1 of 1
[2.0.34] Low powered inserter fails to return when dropping in wagon
Posted: Mon Feb 10, 2025 5:30 pm
by Hares
Steps to Reproduce
- Make an inserter from a circular straight (full & stacked) belt to wagon
- Underpower it (minimal power mode)
Expected:
One of the following
- Inserter can't grab items from belt
- Inserter works but very slowly
Actual:
- Inserter grabs item from belt
- Inserter drops item from belt to wagon
- Inserter attempts to swing back but fails to do so
Re: [2.0.34] Low powered inserter fails to return when dropping in wagon
Posted: Tue Feb 11, 2025 5:12 pm
by Rseding91
Thanks for the report. I'm going to say that this is fine to work this way. At some point, there's not enough power for the inserter to operate normally when combined with a looping belt and the item it wants constantly moving out of reach. The solution is simple: you need to build more power.
Re: [2.0.34] Low powered inserter fails to return when dropping in wagon
Posted: Tue Feb 11, 2025 5:41 pm
by Hares
Rseding91 wrote: Tue Feb 11, 2025 5:12 pm
[...] The solution is simple: you need to build more power.
Yeah, I was trying to fix power outage caused by disappeared signal. And on Gleba I need burnable materials which are made out of fruits. And to deliver fruits, I need trains loaded by inserters.
