[Kovarex] [2.0.32] Placing Multi-Parametrized Blueprint makes next Blueprint with Relative Snap-to-Grid Absolute
Posted: Wed Jan 22, 2025 7:37 pm
I had this issue for quite a while and was not sure what caused it until I did some testing.
Steps to produce the issue:
1. Place a blueprint with multiple parameters (for example an item and a count).
2. Pick another blueprint that have a relative grid checked.
3. Trying to place the second blueprint will behave as if it is an absolute snap-to-grid and not relative.
4. placing anything else will reset the state and the 2nd blueprint will behave as expected.
This is a simple BP Book that contain two BP's to test the scenario:
Place the combinator BP first then the Assembly BP to replicate the issue. For me it happens at least 9/10 times.
Steps to produce the issue:
1. Place a blueprint with multiple parameters (for example an item and a count).
2. Pick another blueprint that have a relative grid checked.
3. Trying to place the second blueprint will behave as if it is an absolute snap-to-grid and not relative.
4. placing anything else will reset the state and the 2nd blueprint will behave as expected.
This is a simple BP Book that contain two BP's to test the scenario:
Place the combinator BP first then the Assembly BP to replicate the issue. For me it happens at least 9/10 times.