Page 1 of 1
[2.0.28] Can't connect transport belt with green wire when it's adjacent to a combinator
Posted: Tue Dec 24, 2024 8:09 pm
by xyzzycgn
Tried to connect a belt with green wire, instead of the chosen transportation belt the adjacent combinator was connected.
The behavior is easy reproducible:
- try to connect belt and click it
- instead of the belt the combinator is connected
Both arithmetic and decider combinator and both input and output side show this behavior.
Re: Can't connect transport belt with green wire when it's when it's adjacent to a combinator
Posted: Tue Dec 24, 2024 8:25 pm
by boskid
Thanks for the report however i cannot reproduce any issues. You seem to have some mods installed, without a save file and reproduction steps there is nothing that can be done.
Re: Can't connect transport belt with green wire when it's when it's adjacent to a combinator
Posted: Tue Dec 24, 2024 9:37 pm
by Muche
OP, did you finish connecting the green wire to a target?
Because in that setup (a belt right next to a combinator) it may look like the wire is connecting to the combinator, but it's indeed connecting to the belt.
Connecting a wire to the combinator looks a little bit differently:
- GreenWireOnBelt.jpg (273.1 KiB) Viewed 338 times
Re: Can't connect transport belt with green wire when it's when it's adjacent to a combinator
Posted: Wed Dec 25, 2024 2:01 pm
by xyzzycgn
Muche wrote: Tue Dec 24, 2024 9:37 pm
OP, did you finish connecting the green wire to a target?
Because in that setup (a belt right next to a combinator) it may look like the wire is connecting to the combinator, but it's indeed connecting to the belt.
Connecting a wire to the combinator looks a little bit differently:
GreenWireOnBelt.jpg
Yep - that's the trick
I was expecting that the belt shows a connection immediately after clicking - AFAIR the behavior in V1
- obviously the same happens even without an adjacent combinator
- 20241225145152_1.jpg (690.61 KiB) Viewed 297 times
- 20241225145155_1.jpg (691.26 KiB) Viewed 297 times
- 20241225145159_1.jpg (672.61 KiB) Viewed 297 times
Sorry for the false positive and thx for the quick replies.