Page 1 of 1

[2.0.20] Train signal upgrade/ghost in remote view plays wrong sound

Posted: Wed Nov 20, 2024 2:56 am
by burninghey
When building a rail signal ghost at existing signals in map view, issueing an "upgrade order" with the other type (rail signal <-> rail chain signal) wrong sound effect is played

Re: [2.0.20] Wrong Sound on train signal upgrade

Posted: Wed Nov 20, 2024 11:12 am
by Donion
Adding to the report, if you keep building the same signal on the same spot it will cycle between placing a ghost and making an upgrade request.
The sound is just a side effect of the buildability logic.

Re: [2.0.20] Train signal upgrade/ghost in remote view plays wrong sound

Posted: Thu May 01, 2025 12:07 pm
by Hares
Still actual on 2.0.47
Steps to Reproduce
  1. Place a chain signal
  2. In a remote view, replace it with rail signal via normal Click
  3. In a normal view while being out-of-reach, replace it with rail signal via Shift+Click
Expected:
  • Upgrade tasks are created
Actual:
  • Upgrade tasks are created
  • Error sound is played, both cases
See Also
Note: To enable sound, use RMB on video -> Show controls -> Click "unmute" button on the bottom-right.
Click to expand the recording

Re: [2.0.20] Train signal upgrade/ghost in remote view plays wrong sound

Posted: Thu May 01, 2025 3:41 pm
by Rseding91
Thanks for the report. This is now fixed for the next release.