[kovarex] [2.0.15] Train interrupts do not take into account blueprint parameterization
Posted: Wed Nov 06, 2024 10:38 pm
What did you do?
I blueprinted a locomotive that had a preconfigured route. I've used blueprint parameterization to dynamically apply certain parameters to train station names. The blueprint is created successfully.
What happened?
When I place the blueprint and choose the parameters, not all of them are replaced. Actually, the only parameter that is not replaced dynamically is the name of a train station in an interrupt.
The first screenshot below shows the route of the train I want to blueprint, using the parameters:
In this second screenshot, I'm using the blueprint parameterization so that two parameters can be selected (the number of locomotives and the number of cargo wagons - using the number symbols):
In this third screenshot, we can see that almost all the parameters have been correctly replaced, except for one: the one in the interrupt train station name (I used "Signal-2" for the first parameter, and "Signal-4" for the second parameter while placing the blueprint):
What did you expect to happen instead? It might be obvious to you, but do it anyway!
I expected all parameters to be correctly assigned thanks to the blueprint parameterization, with none left out.
Does it happen always, once, or sometimes?
Always.
---
Log file Blueprint
Save file
I blueprinted a locomotive that had a preconfigured route. I've used blueprint parameterization to dynamically apply certain parameters to train station names. The blueprint is created successfully.
What happened?
When I place the blueprint and choose the parameters, not all of them are replaced. Actually, the only parameter that is not replaced dynamically is the name of a train station in an interrupt.
The first screenshot below shows the route of the train I want to blueprint, using the parameters:
- "Default" route
- 01.jpg (164.85 KiB) Viewed 633 times
- Setting the blueprint parameters
- 02.jpg (414.58 KiB) Viewed 633 times
- A parameter has not been replaced
- 03.jpg (206.02 KiB) Viewed 633 times
I expected all parameters to be correctly assigned thanks to the blueprint parameterization, with none left out.
Does it happen always, once, or sometimes?
Always.
---
Log file Blueprint
Save file