[2.0.14] I am able to create infinitely long elevated rail segment with only 2 segments in Editor
Posted: Tue Nov 05, 2024 10:54 pm
What did you do?
- On Fulgora, with /editor
- I created an elevated rail segment with 2 ramps
- CTRL-X to cut the second ramp
- CTRL-Y to paste it a bit further from the first
- Use auto-rail placer tool to extend the hanging rail to the new location
What happened?
- Two rail ramps were connected despite being longer than the longest distance allowed
What did you expect to happen instead? It might be obvious to you, but do it anyway!
- Either they should not be possible to connect
- or another ramp should be auto-placed in between them
Does it happen always, once, or sometimes?
- Always. Works in both directions.