[2.0.12] Can't rotate rail signal to place on elevated rail in specific configuration
Posted: Thu Oct 31, 2024 1:43 pm
by sparr
This configuration of rails makes it impossible to place this signal. The signal cursor only snaps to the curved rail, and can't be [R]otated to the other orientation to attach to the elevated rail.
Ditto for a straight rail with the same signal position as the curved rail.
10-31-2024, 09-42-51.png (101.71 KiB) Viewed 422 times
Re: [2.0.12] Can't rotate rail signal to place on elevated rail in specific configuration
Posted: Thu Oct 31, 2024 11:45 pm
by Muche
I was able to switch between placing the signal to the ground rail and elevated rail via G (Toggle rail layer).
Trying to put the signal in that position when both rails are on the same level indeed did not work - only curved rail position was available.
Trying to workaround it by placing the straight rail first, then signal, then curved rail, put the signal into Cannot divide segments error state.
Re: [2.0.12] Can't rotate rail signal to place on elevated rail in specific configuration
Posted: Tue Nov 12, 2024 9:15 pm
by boskid
I am aware of this scenario and thats why i made G (toggle rail layer) binding usable here.