[2.0.11] Lamp's settings don't reset/change when disconnecting one from circuit network.
Posted: Sun Oct 27, 2024 3:17 pm
Sorry if this was mentioned before, and this bug is very minor. For example, when you connect a lamp to a combinator of any kind, then go in the GUI of the lamp and disable it, then turn on the "color mapping" setting (which would normally change the lamp to black), suddenly removing the combinator or the green/red wire connected to the lamp will "trap" the lamp in the black state and this can't be changed. The only way to fix it to remove and place the lamp again, or to reconnect it to the circuit network and change the settings back.
Again, very minor, but I don't see it posted here. Here's a screenshot:
Note that the lamp doesn't reset back to 'normal mode' when disconnected from the circuit network.
Again, very minor, but I don't see it posted here. Here's a screenshot:
Note that the lamp doesn't reset back to 'normal mode' when disconnected from the circuit network.