Fluids are outputting their inputs
Posted: Sat Oct 26, 2024 12:34 pm
I was recently working on Fulgora and noticed that some of my Electromagnetic Plants were jammed due to incorrect fluid inputs, upon replacing the pipes and machines they would jam again whenever the output fluid for one machine ran dry due to being consumed in another machine. This caused the Electromagnetic plant to output one of the input fluids, I tried breaking and replacing the pipes but it would always have 0.0 of the wrong fluid coming out. When I changed the circuits to disable the machines unless theres over a certain amount of fluid in the system the problem went away.
This was only noticed on machines in which I changed the inputs via the new fluid input swapping.
As you can see the one machine making the science packs is attempting to input Holmium fluid despire there being no attached output of it, The above Electrolyte Machine was causing that, It repeated with Heavy Oil upon being replaced untill I did the circuit automation to disable the science pack machine unless there was over 1k Electrolyte in the tank The Heavy Oil causing the same issue The entire system working without error post fix.
This was only noticed on machines in which I changed the inputs via the new fluid input swapping.
As you can see the one machine making the science packs is attempting to input Holmium fluid despire there being no attached output of it, The above Electrolyte Machine was causing that, It repeated with Heavy Oil upon being replaced untill I did the circuit automation to disable the science pack machine unless there was over 1k Electrolyte in the tank The Heavy Oil causing the same issue The entire system working without error post fix.