Factorio Forums

New-ish save (only red and green flasks), about 3h in.

Shortly after placing 2 radars (the 2 first one of this map), I wanted to check how close spawner were (by opening the map with a click on the minimap), and then I wanted to check if some of them ever absorbed any pollution (as they were near the pollution cloud). I opened the pollution tab, and switch from "5s" to "Total" and then back to "1000h".

Right before the crash, I noticed one of the curve (on the left panel : the sources of pollution) were very higher (flatening all other curvess) and had a sawtooth pattern (from the very bottom to the very top of the chart), which actually didn't seem to match anything from my current save.

For the moment, it has only happened once. I might try to reproduce it later this week.

Savefile added, as I can't tell if it map-related or not.

I didn't see on the related post any mention about the "sawtooth" pattern and so on. Do you have confirmation that both cases have the same root cause ?

For information, it happened again (see precisions below + log file) :
This time again, I wanted to check how many spawners have absorbed pollution. It precisely happened when I hovered one of the 2 types. This isn't exactly the case of the other topic, where the inspected value was "at a moment where the production is 0", while there is a total of "2 (about 0.0/min) on the screenshot above.

Please let me know if I need to document this case further, or if I can provide any help.