Factorio Forums

After placing a blueprint and building not all power poles the wire connections will stay with the blueprints even though they could connect directly.

reproduction, place the following blueprint:
0eNqVkdFqhDAQRf/lPmeXGlfU/EqRonbYDsSJJHGpSP59jaVQWCj4OMPMOcydDYNdaPYsEWYDj04CzPuGwHfpbe7FdSYYcKQJCtJPuQpTb+2FLI3R83iZnSUkBZZP+oYpUqdAEjky/eCOYv2QZRrI7wP/ghRmF/ZdJ9mfedW1UlhhdHmtdo0Q378Gt/gML7ukXgT6nEDrs4Ly5AXtr6B+FRRKdzmxI2Lz5yMKD/LhoOimuNWtrhvd1m9Nm9ITzwWRjQ==

build the left and right power pole. The wire goes from both to the blue print, but does not connect the two poles.

problem: no power connection.

My expectation is that if a working power line is possible a ghost image should not interfere with it.

this is similar to the following reports:
viewtopic.php?f=23&t=106040&p=584571&hi ... st#p584571
viewtopic.php?f=11&t=91933&p=523462&hil ... re#p523462

Thanks for the report however that is working as intended. Blueprints remember the electric pole connections and will always use those when built.